This new Brembo “.484” caliper is made entirely from billet, starting with a block of aluminum machined with the most modern CNC technologies available. The two caliper halves are then joined with three steel screws located within the wheel side. The caliper body houses four 32mm diameter pistons.
The name “.484” is derived from the displacement of an individual caliper piston measured in cubic inches. This caliper uses radial mounting technology in order to guarantee maximum operating precision. The brake pads slide in specific guides, machined onto the body of the caliper itself, which allow brake pad pins to be eliminated.
Finishing of the caliper is obtained with an anthracite black hard oxidation treatment. The pair of calipers comes in a kit that includes: pre-mounted sintered brake pads, specific instruction sheet and a pair of Brembo stickers.
No posts found